iPhone 6/6 Plus Screen Replacement
Screen Replacement Guide
15 – 20 Min.
Use the following picture guide to easily change the display on your iPhone & and iPhone & Plus. Make sure that you install the home button from your old display into the new one. Without your original home button, the fingerprint sensor with touch ID will not work.
You should make a backup of your iPhone before changing the display and then turn it off.
Step 1: Remove Pentalobe screws
Remove the two Pentalobe screws on the bottom of the iPhone.
Step 2: Open display
Lift the screen out of the frame using either the suction cup or the thin metal spatula Which of the two you will use depends largely on the state of your screen. If it’s still mostly uncracked, the suction cup will work just fine.
Step 3: Detach display from frame
Drive the plectrum between frame and screen. Be careful not to insert it too far into the device in the area around the home button. Slowly lift up the screen, together with the inner metal frame it is attached to inside the device.
Step 4: Remove cover
Open the screen just enough so you are able to reach these five screws securing the metal cover.
Step 5: Detach connectors
Hidden underneath are four connectors which link the screen to the logic board. Remove them carefully using the plastic spatula.
Step 6: Change Home Button
Therefore, you have to transfer your home button into the new screen. To do this, you need to loosen these two screws first.
Step 7: Detach Home Button connector
Detach the connector on the left. Delicately scrape off the cable using the plastic spatula. It is pretty tough, but be very careful nonetheless!
Step 8: Remove Home Button
Gently press against the home button from the front of the screen towards the rear until it starts to come off. Now you can remove the whole package — button, cables and all.
Step 9: Insert Home Button into new display
Install the home button into the new display the same way you removed it earlier. Match up the loops with the little nubs on the rear side of the screen. When everything fits nicely, gently press down on the rubber part around the button with the plastic spatula.
Step 10: Fasten Home Button connector
Reattach the connector to the display.
Step 11: Fix Home Button on display
Put the metal cover back and secure it with two screws.
Step 12: Attach display connectors
Remove the protective film from the new display and attach these four connectors to the logic board.
Step 13: Fix metal cover
Don’t bend the screen too far back and reattach the metal cover with five screws.
Step 14: Insert new display
Press the screen into the frame of the device. Start at the top near the FaceTime-Camera and work your way down towards the home button. Keep checking if everything is flush and that there are no gaps.
Step 15: Attach new display
Secure everything with the two pentalobe screws.